Safety standards and maintenance methods of fiberglass water park equipment

The water slide is a common type of water amusement facility, generally using glass fiber reinforced plastic materials manufactured into a spiral or linear shape, visitors enter from the entrance, or sitting or lying, sliding down the smooth surface of the slide (with the appropriate amount of water lubrication). The body and the slide surface have close contact, if the slide in the process of use of any problem may cause different degrees of physical or psychological injury to passengers, but also may cause economic losses and adverse effects on the investment operator. Therefore, this fiberglass water park equipment should be safe and reliable. Next is the fiberglass water park equipment should meet the safety standards and its maintenance methods of introduction.

Here is the content list:

l Safety standards

l Maintenance method

Safety standards

On the one hand, the surface of the fiberglass water park equipment should be smooth without cracks, uniform tone, the use of fiberglass should meet at least three requirements: resin should have good water resistance and anti-aging; glass fiber should be used alkali-free glass fiber, fiber surface should have good wettability; thickness should not be less than 6mm, flange thickness should not be less than 9mm.

On the one hand, the inner surface of the fiberglass water park equipment slide does not allow the existence of small holes, wrinkles, bubbles, poor curing, poor impregnation, cracks, defects, and other problems; the back does not allow the existence of poor curing, poor impregnation, defects, burrs, and other problems; the cutting surface does not allow the existence of delamination, burrs, and other problems. In addition, it should also be noted that when observing the fiberglass water park equipment with the naked eye at a distance of 600mm, it is not obvious that repair marks, scars, uneven color, cloth pattern, unevenness, collection, and other problems.

Maintenance method

Before opening daily, the fiberglass water park equipment should be checked to see if the slide has exposed sharp edges, sharp corners, burrs, water leakage, and other phenomena. Water treatment equipment is normal operation, to ensure that the fiberglass water park equipment lubrication water and water supply of the slide drop pool. The connecting parts should be checked and tightened regularly. The load-bearing components should be regularly inspected to see whether the structure has cracks generated as well as bending deformation, etc. So that timely replacement. Fiberglass water park equipment in the non-use period should be covered with plastic sheeting or a coarse cloth to prevent ultraviolet radiation caused by aging, fading, cracks, etc. The cracked slide groove should be replaced (or repaired) in time, and the sliding interface should be handled in time when it is uneven, inverted tab, or cracked. Metal components surface paint layer in the non-use period should check whether there is peeling, fading, if peeling, the shedding phenomenon should make up the paint. To regularly organize safety inspection and maintenance, found that the slide surface with water, gravel, scale, etc., should be promptly cleaned up with cotton cloth or sandpaper, sanding.

HEFEI XINGHAIYUAN ENERGY TECHNOLOGY fiberglass water park equipment is in line with safety standards, please rest assured that the purchase.